Had an issue with water in your BCM, has your ECU failed? If cloning isn't a viable option we can program a new or used module for you.
In some cases the module can be programmed on the bench, but usually we will need the full vehicle for this service.
This is made possible due to our continued investiment into dealer tooling, we have over 99% of dealer tools/software for vehicle manufacturers.
We can normally program a used control unit, or "virgin" it first, if this is not possible we can usually tell you before attempting the process.
Some services such as reverse camera installations, module cloning, AdBlue/DPF, remapping can be done whilst you wait in most cases, however for electrical diagnostic work we advise leaving the vehicle.
We start with an "initial diagnosis", this is the first hour we spend on your vehicle, within this hour we usually identify the cause of the fault/failure and can report back to you with this information for a decision, however if faults are more complex or intermittent, further authorisation may be required, we will however call you prior to proceeding.